Hi All,   We are in planning of implementing below setup, may I request any guidance with regards to the connection of the second Meraki switch since I do not have equipment for the simulation. We do not have Stacking cable for the MS350, can we use LAN cable instead for the set up.         My questions are:   Do the MS350 switch setup need a dedicated LAN cable for warm spare to pass the traffic? If there is a dedicated LAN cable between MS350 switch, the uplink of switch 2 Gi0/1 should be automatically blocked? Is the AP in switch 2 will still work based on the setup that will pass the traffic to the switch 1? What will be the configuration of the ports in dedicated LAN cable? Is below correct? SW1 LAN Port Gi0/2 – trunk with native VLAN 99 and all VLAN are allowed SW2 LAN Port Gi0/2 – same I have seen MX documentation using VRRP, there is a configuration of 1.1.1.1 and VLAN 1111, do I need to do this both in Meraki switch in LAN port Gi0/2? If we will not be using the VRRP configuration in MS switch, is the diagram connection still okay?   Regards, Chris ... View more