Are you routing all of your traffic through Cisco Secure Connect (in case there is nothing to do, protection is permanently enabled, hence that option is now pointless), or have you configured it only for DNS protection?
... View more
>Can we "stack" across a OM4 fibre run in a new location - dual runs? Yes. The MS425s support flexible stacking. https://documentation.meraki.com/MS/Stacking/Switch_Stacks#Understanding_Flexible_Stacking
... View more
Ah ok so I could use the range of AP IP's to route traffic over WAN2 as they have their own subnet. But then again I think it's be neater to use bridge mode with DHCP/Isolation.
... View more
Thanks - our GW for clients and servers is on the core switches at each site with a 0.0.0.0 route to the MX's for internet bound traffic. Logically I can see how and why we could move the solitary switch in our DC to the HQ but it scares me doing that. Never used the concentrator mode and not sure i fully understand it. We did use Meraki client VPN but now we use Cisco Anyconnect to an FTD NAT'd behind the MX's (which isn't the best setup).
... View more
