Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- About NewToNetworking
NewToNetworking
Here to help
Member since Mar 28, 2022
Monday
Community Record
8
Posts
2
Kudos
0
Solutions
Badges
05-19-2022
07:26 AM
I did double check and the switchport is on the correct vlan. The cable test does say that the 3 and 4 are short but I did some research to find that this could be a bug. I have tried changing from auto negotiate to other types with no resolution. The packet capture shows nothing at all on the switch port unfortunately.
... View more
05-18-2022
01:33 PM
I have a badge reader that has been installed but I am getting no signal from the device but it is showing on the Meraki switch that I am getting power to it from the switch. The device is connected to the back of a patch panel then ran to the switch. If I use a POE injector in to the patch panel and connect my laptop I can access the badge reader and configure the network settings. What are your thoughts on the issues I am experiencing? All information is configured the same as other door controllers that are connected to a different switch. Default gateway, IP and subnet mask all look correct.
... View more
04-20-2022
07:32 AM
After pulling a pcap on the switch that the end device is on, it seems that the camera is receiving the SYN but is not responding. I am going to do some more research to triple check all camera configurations. Thank you all for the guidance.
... View more
04-18-2022
01:02 PM
I have a camera on my local network that I am having some issues connecting to. All information seems to be correct on the ports and I am receiving RTSP feed from the camera when I log into the admin device which is connected to another switch but when when I enter the IP of the device from my computer which is on a different VLAN it will not connect. Ping and Tracert have been ran with no result. I think I am missing something simple here and maybe over thinking it. Also I am able to ping other devices that are on different VLANs that are on the same switch as the device that I can not connect to. Thank you all for your help in the past and I look forward to hearing what solutions you may have! Let me know what other information that I can provide that may help in troubleshooting.
... View more
03-29-2022
02:48 PM
1 Kudo
Thank you for the assistance. Through some troubleshooting I found that the subnet that I was connecting from was not enabled to use the VPN. After enabling I was able to connect just fine.
... View more
03-29-2022
06:31 AM
I checked again on the firewall rule and they seem to be okay. Yes I can ping the remote gateway. Trace route shows that I am connecting to the gateway while only showing one hop over the network. Some of the others do not respond to trace route it seems.
... View more
03-29-2022
06:28 AM
To your first question, I am not sure. I will try and figure out a way to check on that. To the second question, no I am not able to ping vlan ip of the remote subnet. Using Meraki I can see that the status on both sides are good and I can see that there is source and destination traffic. I am very new to networking and understand most basic concepts so maybe I am just skipping or missing something obvious lol.
... View more
03-28-2022
02:45 PM
1 Kudo
I have a site to site connection setup but between two buildings and it seems that there is traffic but when I ping a computer on the other end I get nothing. Subnets do not overlap and appropriate subnets are enabled. NAT is set to auto on both ends. Firewall rules look to be okay. What trouble shooting steps should I try to test and resolve this issue? Any help is appreciated.
... View more
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 1 | 187 | |
| 1 | 299 |
