Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Matt_P68
Matt_P68
Comes here often
Member since Feb 15, 2022
Dec 15 2023
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Oct 17 2023
1:00 PM
i'll run packet capture, but all I've done is change my DNS server IP on my pc to 8.8.8.8 and it's bypassing umbrella.
... View more
Oct 17 2023
12:05 PM
these are the rule changes suggested by Umbrella: Essentially, add the following filter or rule to the firewall that is at the edge of the network: ALLOW TCP/UDP IN/OUT to 208.67.222.222 or 208.67.220.220 on Port 53 BLOCK TCP/UDP IN/OUT all IP addresses on Port 53 I have an Allow all rule at the end of the rule list, but these should take precedence, I believe.
... View more
Oct 17 2023
9:53 AM
Trying to block all DNS queries to DNS Servers other than Umbrella. Here are my rules, but I'm still able to change my DNS server and get to the internet. What needs corrected? TIA
... View more
Oct 12 2023
7:04 AM
I have 2 MR70 access points as a bridge to another building. (Office side and remote side) Inside the remote building i have the bridge MR70 plugged into a MS-120 switch (which is providing the PoE to the MR70). I also have an inside access point MR36 plugged into the MS120 to provide wifi access inside the building. The switch will not come online with the MR36 plugged in. The MR36 is using the Office side MR70 as it's gateway. I have checked the option "When devices are plugged directly into an access point they should behave as -- they are a part of the primary SSID" Is there a way to force the inside access point to not use the office side access point but to go through the switch and the remote side MR70 for it's path to the network? This seems to be preventing the switch from accessing the Meraki cloud.
... View more
Oct 5 2023
9:50 AM
we have several MX in our org. I have a one that I need to establish a vpn tunnel to a non-meraki peer. But to get that option available, you have to enable site to site vpn and select a Hub or Spoke to connect to. I don't need a connection to any of the other Hubs or spokes but I don't seem to the option of not selecting one so i have access to the non-meraki configuration below that in the dashboard.
... View more
Oct 5 2023
6:37 AM
I need to configure a site to site vpn from an MX64 to a non-meraki device at our hosted ERP vendors datacenter. I don't need any other site to site vpn's but it looks like it forces me to select another hub to connect to in order to get the non-meraki vpn configuration. Is there any way around this?
... View more
Labels:
- Labels:
-
3rd Party VPN
-
Auto VPN
Feb 15 2022
4:23 AM
Having same issue with last 2 orders
... View more
© 2024 Cisco Systems, Inc.
