cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About JFLush

Monitoring timeouts?

by in Dashboard & Administration
‎05-11-2022 01:50 AM
‎05-11-2022 01:50 AM
Hi all,   I'm currently working on getting our PRTG instance to report on Meraki devices via API, but at this time PRTG only works with numbers, not text fields. As such, I'm trying to at least get SNMP setup.   I have access to two organizations, one has about 50 devices in, one has almost 800. When I setup PRTG to find the devices using the OID 1.3.6.1.4.1.29671.1.1.4, for the org with 50 devices, it brings up the custom table, when I do it on the org with 800 devices, it always times out. The only difference I can see is the amount of devices. Is there something about trying to poll lots of devices that just doesn't work? I'm trying to work out if this is an issue Meraki side or PRTG side. I've tried increasing the timeout, but 10 seconds is fine for the 50 org, 30 seconds still fails on the 800 org. ... View more

Re: Monitoring in PRTG using SNMP

by in Dashboard & Administration
‎01-13-2022 04:37 AM
‎01-13-2022 04:37 AM
Quite a lot of people seem to have got it working, even if it uses work-arounds, so I was hoping someone who has got it working might be able to offer some advice. I've tried following the article on the Paessler site, but it isn't working for me, so not sure if I'm doing something wrong.   When I try to walk devices via connection to the cloud controller, it doesn't return any devices, I don't think this is a PRTG thing? This is just an SNMP thing isn't it? ... View more

Monitoring in PRTG using SNMP

by in Dashboard & Administration
‎01-12-2022 05:38 AM
‎01-12-2022 05:38 AM
Hi,   Sorry if this isn't the best section, I'm just going by previous posts about SNMP.   I'm looking to get all our Meraki devices present in our PRTG, but I'm having issues with it. I've liaised with PRTG, but they've pushed me in this direction.   I've set up SNMP in Meraki, got the address, community string and port etc setup in PRTG, but when I use the OIDs from the MIB, it imports all our devices with really weird names containing random symbols, so I can't work out what device is what.   PRTG asked me to do some tests with their SNMP tester, but when I try and walk or scan for interfaces, none are found, so I'm wondering if I've not configured something?   Thanks, Jack. ... View more
© 2022 Meraki