Can you give more into on what device that is happening for? Are you running up to date firmware versions for the devices in your the Meraki system? I haven't seen the problem I posted about above in 2022 in a long time, so I guess it got fixed in a firmware update (or driver or OS update on the device having trouble).
... View more
Hi, I have never tried it on an MX, but you could try using a source-based route at the bottom of addressing and vlans page. just be very specific and careful, as you can take down your whole network.
... View more
Thanks for elaborating on your setup! I did try using a Mac running Windows 10 the other day and there it was no trouble accessing any of the internal websites and having: Synology DNS 8.8.8.8 8.8.4.4 deployed via DCHP. What I did now was to change in Meraki so it only deploys (via DHCP) the DNS coming from Synology. The Synology itself will forward addresses it can't resolve to 8.8.8.8 and 8.8.4.4. Seems to work fine now and I don't get the wired behavior for internal addresses depending on the browser used in MacOS that I described in my original post. At the same time I think it would be good to have a DNS backup in case the Synology goes down. So I'll continue to investigate what this behaves the way it does in MacOS.
... View more
The reason for my trouble in this thread was that we had ”Statics routes” setup in: Security & SD-WAN -> Addressing & VLANs And the IP address for https://securelogin.bmw.com/ was covered within that range and therefore the the traffic was being routed internally instead of externally. Sorry for the confusion and thanks all for trying to help! 🙂
... View more
A bit unsure how to set it up. If I just need VPN tunneling to a few specific IP addresses on our LAN, how do I specify that? Would that help with performance instead of routing all traffic via the VPN (I guess it would)? Sorry for my ignorance and thanks for the help!
... View more
