Meraki

Community

About dmcritchley

Introduction

by in Community Member Intros
‎Apr 5 2021 5:55 AM
1 Kudo
‎Apr 5 2021 5:55 AM
1 Kudo
1. I’m currently WFH but looking for a new role. 2. Have a small Meraki network I built myself: MX67 connected to a fibre broadband service (replaced Netgear); MS120-8FP switch connecting 2 x MR36 Wireless APs and 2 x Ubiquiti APs (legacy devices). Plan to replace Ubiquiti with two more MR36 and MR76 for external use to complete network. 3. Looking for insight and problem solving (not too technical ideally). Have solved two issues already around Kindle connections and HP Printer connection. Would like some advice around security set up in particular. 4. Fun fact is I worked for Cisco for nearly 16 years and was there when Meraki was acquired. ... View more

Re: HP Envy 5530 e Fails connecting to AP

by in Wireless
‎Mar 26 2021 7:45 AM
‎Mar 26 2021 7:45 AM
how did you do those changes? ... View more

Setting up HP Envy for wireless printing

by in Wireless
‎Mar 26 2021 7:41 AM
1 Kudo
‎Mar 26 2021 7:41 AM
1 Kudo
I have a small network of MR67 router connected to fibre broadband service; a MS120 8 port switch and some APs (2 x MR36 and 2 Ubiquiti ones).   I have an HP Envy printer connected to one of the APs which I would like to set up so anyone can wirelessly print from anywhere on the network. The device is visible from the Meraki Dashboard so is set up for wireless printing which you can only do if you directly connect to it vs through the network. What do I need to set up in the Meraki Dashboard to allow this wireless printing from anywhere?   fixed by changing from NAT to Bridge mode   Also in terms of general security set up what should I do on the MR67 and MS120 to protect them or is the AP security sufficient to prevent intrusion? ... View more
© 2024 Cisco Systems, Inc.