@JorgeRJimenez  The below article should give you all of the information you will need.     https://documentation.meraki.com/SM/Device_Enrollment/Enrolling_Devices ... View more

To add to @ww 's comment, you only need the management port for initial configuration.  Once the switch is up and running and connected to the Internet you don't need to use it anymore.  In fact if you can plug in the switch to somewhere where it can get a DHCP address you wont need to use it at all.  It just needs to connect to the Internet once to be able to download its config.   You can get the MS120 to use vlan 228 for its access to the cloud via the local status page and configuring the "uplink configuration": https://documentation.meraki.com/zGeneral_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Meraki_Device_Local_Status_Page#MS_Series   Or once the switch has connected to the Internet once you can do it via the dashboard: https://documentation.meraki.com/MS/Other_Topics/Switch_Settings#Management_VLAN   ... View more

Thanks so much, i think the point of this its becouse i missundertand the concept, Meraki Warm Spare works only with two ISP at the same time, if i want to enable more then 3 or 4 ISP we need to use MX separate and its different for Meraki warm spare concept and recomendation. ... View more