- About mediel101
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Community Record
17
Posts
0
Kudos
0
Solutions
Badges
03-04-2018
09:47 PM
Hi sir @MerakiDave, I couldn ping the AP now. "Ping AP" result below:
... View more
03-04-2018
09:41 PM
@MerakiDave yes sir I can see which SSID it's broadcasting And when you "Ping AP" it only keeps loading..
... View more
03-04-2018
09:23 PM
Hi sir @MerakiDave AP is online and green in Dashboard and when you unplug the AP it goes offline/red in Dashboard. And also no schedule SSID Availability.
... View more
03-04-2018
09:17 PM
@PhilipDAth yes sir up to date and same way if you power off mr32, it's also offline on the dashboard.
... View more
03-04-2018
07:26 PM
@MerakiDave I already configured it to static IP and now online to dashboard but not broadcasting SSID of what I setup on meraki dashboad.
... View more
03-04-2018
05:47 PM
Hi, experiencing not broadcasting correct SSID on MR32. Still broadcast the default SSID " Meraki Setup" and not what I configured on the dashboard. Big thanks,
... View more
02-25-2018
05:51 PM
Thank you Ma'am/Sirs for sharing your ideas. But eventually Cisco support engineer identifies the problem and now making steps for RMA to replace our MR32 device. Thank you.
... View more
02-22-2018
04:53 PM
Connected to local status page and can provide internet access to the users but unreachable to the dashboard.
... View more
02-22-2018
04:50 PM
I tried it already but when you configure it to static via dashboard, it backs to the old static config.
... View more
02-22-2018
04:47 PM
Yes sir, it's the same MAC Address.
... View more
02-22-2018
12:04 AM
Yes, I already set a static IP for cloud communication through 10.128.128.128. But on AP dashboard, it automatically show the old IP configuration even you remove it and add again.
... View more
02-21-2018
11:48 PM
I've tried it already but still comes back the old AP configuration to meraki dashboard.
... View more
02-21-2018
10:23 PM
Please see image below if this what you mean. Thanks
... View more
02-21-2018
07:53 PM
After factory reset of MR32, the device now can't configure to dashboard. I put static IP to MR32 using "meraki scanning" default SSID of MR 32 and now connected to internet and can provide internet to users but unreachable to dashboard that's why I can't configure it to meraki cloud.
... View more
