Meraki Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About NadiaK

Re: How to change port priority for STP?

by in Switching
‎Apr 22 2021 8:02 AM
‎Apr 22 2021 8:02 AM
Thank you for your answer.   > What is the reason you need to do this? To control traffic path and avoid situation like this (I had it without any physical issues with links and ports): Unfortunately I cannot configure MX as a root bridge, because "The MX does not run STP in any capacity, and will not exchange BPDUs with other switches or participate in the root bridge election process". So I hoped to control my active topology by port priority. ... View more

How to change port priority for STP?

by in Switching
‎Apr 22 2021 5:11 AM
‎Apr 22 2021 5:11 AM
Is it possible to change switch port priority for STP? I found only bridge priority configuration which affect to root-bridge election.   But I would like affect to root-port election.  Some network equipment allows to change port priority, but I don't see this possibility for MS-120.   Can I do it? Thank you in advance ... View more

Re: Metrics in MX static routing and GLBP options

by in Security & SD-WAN
‎Feb 10 2021 3:23 AM
‎Feb 10 2021 3:23 AM
Thank you Philip. But I meant balancing between two MX. Something like GLBP. ... View more

Metrics in MX static routing and GLBP options

by in Security & SD-WAN
‎Feb 9 2021 7:42 AM
‎Feb 9 2021 7:42 AM
Hi everybody. As I understood from documentation static routing in MX are used only for LAN communications.   Is it true? 1) Can I use static routes to ISP? 2) How can I use metrics in route? I don't see any fields for it.   If it's impossible, what is the right way to use two MX in balancing mode? Not in failover like MX Warm Spare, but in balancing, something like with Cisco GLBP?   Thank you in advance. ... View more

Re: Only "Proxy to upstream DNS" mode works

by in Security & SD-WAN
‎Oct 2 2020 4:45 AM
‎Oct 2 2020 4:45 AM
Thank you Claes_Karlsson. It was firmware issue. After update everything works! ... View more

Only "Proxy to upstream DNS" mode works

by in Security & SD-WAN
‎Sep 25 2020 7:20 AM
‎Sep 25 2020 7:20 AM
MX-100, Firmware MX 14.42     My DHCP is configured with DNS option "Proxy to upstream DNS".   I would like use another DNS. But with options "Use Google public DNS" or "Specify nameservers" (list of Google and other tested servers) DNS doesn't work for users at all, even after reconnect and DNS cache clean up.   Who faced up with the same issue? What should I check?   Thank you in advance. ... View more
© 2024 Cisco Systems, Inc.