I can see that the traffic to the both public IP's is going on the client VPN tunnel. But in phase 2 ike - encryption domain I don't have these routes on the ASR where the Meraki is connected to. I just don't knwo how to send them with the MX.   KR, ... View more

Hi, This is not what I'm searching for. I already have the WAN2 as primary uplink (as there is a flow preference problem for VOICE, and Meraki advised this setup as solution). Now I want the clinet vpn to go over the secondary WAN (WAN1). Is there a way to change the flow preferences so I this is possible? KR, ... View more

Hi,   Did you follow : Configuring_a_Physical_Switch_Stack_Video   Add the switches into a Dashboard network. This can be a new Dashboard network for these switches, or an existing network with other switches. Do not configure the stack in Dashboard yet. Connect each switch with individual uplinks to bring them both online and ensure they can check in with the Meraki Dashboard. Download the latest firmware build using the Firmware Upgrade Manager under Organization > Monitor > Firmware Upgrades, if they are not already set for this. This helps ensure each switch is running the same firmware build. With all switches powered off and links disconnected, connect the switches together via stacking cables in a ring topology (as shown in the following image). To create a full ring, start by connecting switch 1/stack port 1 to switch 2/stack port 2, then switch 2/stack port 1 to switch 3/stack port 2 and so forth, with the bottom switch connecting to the top switch to complete the ring. ... View more

Hi @Upendra,   Maybe this article can help you :   Tagging Client VLANs with RADIUS Attributes   Be sure to activate radius override. ... View more

It was handmade to put the rack on top of it but then we found a much better stand between the junk 🙂   ... View more

Just for fun another cleanup 🙂 Switches and router are from Cisco but Wifi is Meraki.   Before After ... View more

@Uberseehandel   Hi,   We used  : https://www.tridis.be/en/patch-cable-u-utp-category-6-0-15m-violet-utp-snagless and  https://www.tridis.be/en/patch-cable-u-utp-category-6-0-15m-green   We always use this with a 48-ports switch in combination with 2 x 24 patchpanel around it.   See also this one (new rack - no before and after with an MX65).       ... View more

Removed a fortinet + cisco + aerohive disaster and replaced it with the MX84 + MR42 AP's + Cisco SG300. Cable cleanup and cabinet rearrangement did most of the cosmetical cleanup 😉         ... View more