This worked fine for us. We had to give the MXs internet access over the WAN1 interface for them to establish the VPN tunnel, and we had create a transit LAN for the MX to reach the LAN subnets. ... View more

I did this recently with an MS410. I had I one running as the distro and I added another one to it. It was interesting, while Meraki support said I will lose the config when I stack them that didn't exactly happen. Here's what I did and what happened:    1-Bring the new switch up have it check it with dashboard  2-Make sure both switches are on the same version  3-Power both switches OFF and cable the stack  4-Power the switches back on  5-Go to switch ---- switch stacks and provision the new potential stack  6-Dashboard will prompt you if you want to clone or ignore the configuration to the stack. Obviously you want to clone it so you don't lose it and I cloned it.    The Stack came up just fine but here's the issues I ran into:    1-The sapnning-tree priority went back to default so all my access layer switches had spanning-tree related issues. What I recommend is shutting down the downlinks to you access layer switches, once the stack comes back up lower the priority on it again and turn your ports back up (that's if you're stack is a distribution ofcourse)    2-I lost all my aggregate ports configuration that I had on switch 1, I had to rebuild them    3-And last when you stack them the L3 vlans will have a new mac-address so flush your ARP table and such.    Thanks  ... View more

Hi, thanks for the reply. So each site gets NAT'd to the WAN interface IP of the MX at the specific location?  ... View more

Thanks for all your answers. We will be turning this up tomorrow. Internet circuits are not in yet so we will be installing a  temp MG21 to get us going.    How can I get get this setup?    Connect the MR21 1st port to the MS to get it powered via POE Connect the MR21 2nd port to the MX wan1 port    once the DIAs are in move the MX WAN ports to the MS corresponding vlans?    Will this work to get the devices registered with Dashboard?  ... View more

Thanks guys. I'm clear now. I want to ask you one more questions about wireless guest authentication via QR code. Is that something doable? If so can you provide me with a configuration guide and or limitations and licensing needs? Thanks  ... View more

  It’s actually a stack of 3 switches and that’s how I pretty much got them connected. What about the LAN interfaces? Is one shared IP is enough? Heres a diagram. ... View more