Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About cjouglard-UDI

Re: Please introduce yourself

by in Community Tips & Tricks
‎Jan 8 2018 6:55 AM
2 Kudos
‎Jan 8 2018 6:55 AM
2 Kudos
Naher, Try the documents at these two links as a starting point.   https://documentation.meraki.com/MX-Z/Site-to-site_VPN/Site-to-site_VPN_Settings   https://documentation.meraki.com/MX-Z/Installation_Guides/vMX100_Setup_Guide_for_Microsoft_Azure#Azure_Setup   Best regards, Charles Jouglard     ... View more

Re: Controlling access to certain subnets by certain clients

by in Security & SD-WAN
‎Dec 28 2017 2:52 PM
‎Dec 28 2017 2:52 PM
One other piece of Information I may have missed providing. The POS devices and each of the four groups of users that require access to the POS devices are each on their own seperate IP Blocks and VLANs. ... View more

Re: Controlling access to certain subnets by certain clients

by in Security & SD-WAN
‎Dec 28 2017 2:39 PM
‎Dec 28 2017 2:39 PM
Thanks. As I stated I did apply it to the VLAN and the individual clients. And everyone was still able to access the end points. I will try this again first thing tomorrow morning. ... View more

Re: Controlling access to certain subnets by certain clients

by in Security & SD-WAN
‎Dec 28 2017 2:19 PM
‎Dec 28 2017 2:19 PM
PhillipDAth, I have followed the guide and tried multiple options without success. I have applied the Group Policy to the clients and the VLAN and clients that are not applied to the group policy can still access the end POS devices. One challenge I have is the site has Meraki MX84's and another vendor's APs. I do not believe this should cause an issue since I am attempting to control access via the MX84's. ... View more

Re: Controlling access to certain subnets by certain clients

by in Security & SD-WAN
‎Dec 26 2017 6:16 PM
‎Dec 26 2017 6:16 PM
Thanks PhillipDAth, I will give this a try. ... View more

Controlling access to certain subnets by certain clients

by in Security & SD-WAN
‎Dec 26 2017 3:03 PM
‎Dec 26 2017 3:03 PM
I am working on a site with four locations and a MX84 at each location. I have several subnets on each MX84 and one of the subnets is for POS devices. I need to limit access "to" these subnets/ POS devices over the network from/by "specific" clients. The clients that need access are spread across the four sites. I have reserved or set fixed IPs for the clients that require access. Has anyone made anything like this work before?     ... View more

Re: Please introduce yourself

by in Community Tips & Tricks
‎Dec 26 2017 2:56 PM
1 Kudo
‎Dec 26 2017 2:56 PM
1 Kudo
I'm Charles from New Orleans, working to continue to grow my Meraki knowledge. ... View more
© 2024 Cisco Systems, Inc.