Looks like it will happen 🙂 Products - Cloud Management for Catalyst FAQ - Cisco ... View more

The static IP you configure would not reflect on dashboard when Meraki AP isn't able to communicate with the portal. This is expected when AP doesn't receive ARP reply from configured Default Gateway. When AP cannot reach its DG, it falls back to last active config.    I had similar experience, when I tried to Re-IP APs. Steps I followed that helped me were: Change static IP config on AP, followed with switch port config ( put port in new VLAN). This made AP pick up new IP.   If you see config- up to date in left bottom corner you can do a packet capture to check on what's happening.   ... View more

Thanks, but these are the older AnyConnect 3.1 clients. I've looked at both their configurations and the ASA's VPN settings and don't see Trusted Network Detection or anything that looks like it. Maybe with the 3.1 client it's something you can't turn off? ... View more