- About lmc-jkelly
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
lmc-jkelly
Comes here often
Member since Dec 19, 2017
09-28-2018
Community Record
5
Posts
0
Kudos
0
Solutions
Badges
01-17-2018
05:54 PM
Thanks, but these are the older AnyConnect 3.1 clients. I've looked at both their configurations and the ASA's VPN settings and don't see Trusted Network Detection or anything that looks like it. Maybe with the 3.1 client it's something you can't turn off?
... View more
01-17-2018
02:28 PM
We have four Meraki WLANs going. On one of the main ones, when users join, if Cisco AnyConnect VPN client is installed on their device, it pops up. This isn't a big problem, but it's annoying. Why is it doing that? How can I stop it? The WLAN where this happens uses WPA2 encryption and AD authentication. The hosts are Windows 7 laptops/PCs in a Windows Active Directory environment. Thanks,
... View more
12-19-2017
12:21 PM
There are four other APs at the same site, plugged into the same switch, that have no problem at all. Only this one says it has problems communicating with Meraki. I think I'll try your DHCP trick just to teach it a lesson. The IP address is definitely unused.
... View more
12-19-2017
12:19 PM
Yes, it's vacant. No response to pings, no entries in arp table after ping attempts.
... View more
12-19-2017
10:42 AM
I have two MR42s that will not accept the IP address I want to give them. One stubbornly holds on to the first address I gave it, a.b.c.97; I have tried many times to change it to a.b.c.96, but the AP never remembers the change--it doesn't respond with an error message or anything, in fact when I click on the "edit" icon a table with all the right values comes up, so it's storing the information somewhere--but the address never changes. Another AP got an address from DHCP a month or two ago, a.b.c.129; I want to give it a static IP address (like all the other APs at the site), a.b.c.100, but I might as well be talking to a cat. I have rebooted and power-cycled both APs. What else can I do without going to the sites in question, getting on a ladder, and doing a manual factory reset? Why are these boxes sometimes so stubborn about IP addresses?
... View more
