Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Jan 19 2020
4:42 AM
I am trying to deploy MX250 as hub to support warm spare mode the question is on M250-1 i have 192.168.13.10 on wan1 interface with 192.168.13.11 as virtual ip on M250-2 the physical address on wan1 interface should be 192.168.13.10 or 192.168.13.12 with virtual ip being 192.168.13.11 ??
... View more
Jan 18 2020
9:15 PM
Hub1-------Hub2 ------Spoke Spoke is configured with Hub2 being the default route, However i see all the routes from Hub1 on the Spoke pointing with next hop as Hub2, Is it possible to see only the auto-vpn routes from Hub2 and a default route ponting with nexthop as hub2 on the spoke ? Similarly can i apply policy to install only selected routes from Hub1 on Hub2 ?
... View more
Jan 16 2020
9:33 AM
I am trying to create a site-to-site VPN on MX250 as Hub and i see there is only one default subnet 192.168.24.0/24 available and i set the vpn participation off for this default subnet. When i try to save the changes i see an error message asking me to confirm that "there is an overlapping subnet 192.168.0.0/12 " across other networks within my organisation. While it is true that we do have this subnet on other site, i am unable to 1. Modify this default subnet 2. Delete this default subnet 3. with vpn participation set as off, this subnet should not be advertised to other sites hence overlap should not be a problem, but i am worried if i have to continue saving the config even with this error as it might cause routin issue on other sites. Please suggest if anyone has dealt with this kind of issue earlier ?
... View more