Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About jay-junkbrands

Re: MX18 - is yellow brown in the portal with a VLAN warning

by in Wireless
‎Oct 31 2019 7:45 AM
‎Oct 31 2019 7:45 AM
Any ideas why specifying a VLAN that matches the native VLAN would cause this issue? ... View more

Re: Expanding MS210 Stack Throughput With LACP

by in Switching
‎Oct 25 2019 8:54 AM
‎Oct 25 2019 8:54 AM
Thanks for the direction, Nash. Looking through that thread clarifies that I can't aggregate.   Do you know if it would work as a failover technique to just have one non-aggregated uplink on each MS210? I understand that only one would work at a time, but if one switch were to go down, in theory the other would activate the redundant line, correct? ... View more

Expanding MS210 Stack Throughput With LACP

by in Switching
‎Oct 25 2019 8:44 AM
‎Oct 25 2019 8:44 AM
Hi all, I'm struggling to find clear info on this and I was hoping you could weigh in on my situation.   I just got in two MS210 switches which I've made into a physical stack, and connected the stack to our existing MX84 via SFP. I know that the MS210's can do link bonding via LACP, and I was hoping to bond two SFP uplinks from the stack to the MX84 to make a total 2Gbps throughput, but when I attempt this it takes the switches offline. Is this even possible, or am I misunderstanding?   If not possible, it would be nice to at least have a line on each switch for failover reasons. Would that be possible?   Thanks,   Jay ... View more
© 2024 Cisco Systems, Inc.