Meraki

rahmad · ‎Jul 18 2020

Hi @tannermoreno With my workaround setup as i explained above, everything is working fine so i don't think it's configuration issue.

Bettencourt · ‎Jul 18 2020

I'm not sure if your clients are Windows, but if they are ensure you are not forgetting to add the VPN routes manually or via some preferred 3rd party tool. https://documentation.meraki.com/MX/Client_VPN/Configuring_Split_Tunnel_Client_VPN Note: This configuration involves manually adding entries to a client's route table, and should only be followed by users with a thorough understanding of routing mechanisms.

tannermoreno · ‎Jul 18 2020

Hi SarthakRane If you want to validate the port activation configuration and speed validation (10/100/1000) you can run it through Web Configuration Or if you want to validate the logical settings (Vlans, IP Address, Mode Port [Trunk, Access]), you can run it through the Meraki dahboard, section Security & SD-WAN -> Addressing and Vlans. I hope the information is useful to you. Regards.

Meraki

Community

About tannermoreno

tannermoreno

Community Record

Badges

Re: MX84 Interface Red LED

Re: Split Tunneling over remote VPN

Re: How to check LAN intetrface config in MX64/MX450 Appliance ?

Re: Split Tunneling over remote VPN

Re: MX84 Interface Red LED