About kuni

kuni

Thank you, You mean to set vIP, It needs static IP not dynamic IP, right ?

kuni

Thank you NolanHerring, But my question was not /29 bit issue. I'd like to know that whether it needs static ip or dynamic ip when I set vIP. There are two types IP(static ip and dynamic ip) in Public IP. Static IP is more expensive than Dynamic IP. Thank you,

kuni

Thanks ww for your answer. I think I can get /29 ip address(Dynamic IPs).

kuni

I have a question about vIP of MX setting. When I set vIP, It have to put IP address. In this case, If I set vIP should I get static IP from ISP ? If I get only dynamic IPs(no static IP) from ISP, How can I set vIP ? Thank you,

kuni

Thank you for your comment. I'd like to use the traffic both of them. In case of internet traffic will connect site-to-stie VPN. Please refer the below information. MRs---MS C---MX---MS A --------------Internet---MX ---MS B --- Router ---MPLS---Router I know Meraki can't control mpls protocol directly so I will install router in front of Meraki device. In this case, should ISP set vlan for Meraki MS ?

kuni

We have MPLS and Internet line. So, I'd like to do setting on MX. But because of IP issue, I have to set MS device in front of WANs. I'd like to know whether this is working well or not. Please refer the below connection. MRs---MS C---MX---MS A ---Internet ---MS B ---MPLS In case of MX, I will set load balancing. Thank you, Waiting for your good solutions.

kuni

Thank you for your answer. You mean that to use dual active, It needs to set dual WAN, right ?

kuni

Hi guys, Please refer the below picture. Is it possible ?

kuni

Main circuit : MPLS Backup circuit : Internet (Site-to-Site VPN) In this case, Does a MX can support dual active ? I'd like to send traffic both MPLS and Internet as active-active. Is it possible ?

kuni

Community Record

Badges

Re: vIP Setting Issue

Re: vIP Setting Issue

Re: vIP Setting Issue

vIP Setting Issue

Re: WAN connection Issue

WAN connection Issue

Re: Does MX device can support dual active ?

Warm spare active-active

Does MX device can support dual active ?