Meraki Community

JackShep · ‎Jan 18 2024

Thank you, I just noticed that they are using access ports between the MX and the L3 Stack. I had everything using trunk. Wonder if thats part of the problem.

JackShep · ‎Jan 18 2024

Hello Everyone, 1.) We have an MX105 Pair connecting to an MS425-32 stack thats acting as our core at a site. 2.) The MS425 stack is handling all layer 3 and has OSPF running 3.) the MX105 only has a transit VLAN on it My questions are: How would you configure the uplinks/Transit VLAN between the MX and Core? On the MX should I even define VLANs or should we use the default Single LAN ? The Single LAN option shows as VLAN 0, so what should the port settings on the switch side be? Should I be allowing all VLANs to pass for the Merakis to track clients correctly? Should I be using Storm Control on the MX uplink ports?

JackShep · ‎Aug 16 2023

If I aggregate 4 ports on an MS425 stack, can I connect the (4) SFP adapters from a cable like this (Cable Matters 40GBASE-CR4 Passive QSFP+ to 4X SFP+ DAC Twinax Breakout Cable (QSFP to SFP Cable) - 1m, 3.3ft https://a.co/d/3RDXytI) to the agg ports and then connect the other QSFP male end into a qspf+ port on an MS355-48X2 and us that as uplink?

JackShep · ‎Oct 1 2019

Do you think disabling the unused ports would do the trick? Or will I have to put a layer 3 device between my core and MX?

JackShep · ‎Oct 1 2019

Its Meraki end to end, MX250 pair going to MS-425 stack

JackShep · ‎Oct 1 2019

Anyone know what this means? The Colo Switch stack is designated as the STP root. Should I worry about this? Anyone know how to correct it?

Meraki Community

About JackShep

JackShep

Community Record

Badges

Re: Uplink/Port settings from L3 Core to (L3?) MX

Uplink/Port settings from L3 Core to (L3?) MX

Can I use Twinax breakout cables as meraki uplinks?

Re: not enough information to draw the root of this network?

Re: not enough information to draw the root of this network?

not enough information to draw the root of this network?