Meraki

JorgeL · ‎Nov 4 2019

Thanks, I will try to call the TAC to use the BETA version. Jorge

JorgeL · ‎Nov 4 2019

Thank you for your response, this means that without internet it is not possible to use AutoVPN ?? Is it better to have 2 internet uplinks that 1 internet uplink and 1 of MPLS? Tks Jorge

JorgeL · ‎Nov 3 2019

Hi people, I hope you can help me, attached a diagram: In the Datacenter we have the MX250 in NAT mode, with the Internet1 port connected to ISP with internet (with access to the Meraki dashboard), and the Internet2 port connected to ISP with MPLS only. In the branch it is the same, we have the MX67 in NAT mode, with the Internet port connected to ISP with internet (with access to the Meraki board), and port2 (setting as uplink) connected to ISP with MPLS. Through the Internet link, the MX devices connect and registry to the dashboard and build VPN, but the MPLS link no found, the port status is "Failed" on both sites: The transport on the MPLS link was tested, the connectivity is sussesfully. What configuration do you recommend to provide the 2 operational uplinks (Internet and MPLS)? Tks Jorge

JorgeL · ‎Sep 2 2019

Thanks for answering, but I dont have /29. You know if it is possible to place the MX with Active/Active (primary / secondary) to make the Auto-tunnels end in the primary MX in the topology Hub-Spoke?? to load balance the Spoke traffic:

JorgeL · ‎Aug 30 2019

Hi Community, I have 2 MX 250 configured with Warm Spare but only have 2 connections physical to different ISPs, Its possible that ISP 1 connect physical to MX-1 on WAN1 and ISP2 connect physical to MX-2 on WAN2 to load balance (two MX send traffic to the wans) ?? Tks for answering. Best Regard Jorge L.

Meraki

Community

About JorgeL

JorgeL

Community Record

Badges

Re: SDWAN with 2 uplink Internet and MPLS

Re: SDWAN with 2 uplink Internet and MPLS

SDWAN with 2 uplink Internet and MPLS

Re: MX Warm Spare

MX Warm Spare