Hi RubenL   Only one tunnel ... View more

You can always filter the traffic with the following rules, please note that the maximum packet capture duration is 432000 seconds, the capture will stop after 60 seconds, or when 5000 packets have been captured.   host 10.20.30.40 packets to and from ip address 10.20.30.40 host 10.20.30.40 and port 80 packets to and from ip address 10.20.30.40 and TCP or UDP port 53 (DNS) icmp[icmptype] != icmp-echo and icmp[icmptype] != icmp-echoreply all ICMP packets that are not echo requests/replies (i.e., not ping packets): ether host 11:22:33:44:55:66 packets to and from ethernet host 11:22:33:44:55:66   It is always preferred to run the packet capture without the dashboard filters and use Wireshark filter when we want to check inside header values (i.e. caller and calling station id in radius packets)  ... View more

@MattPainter  Given its a storage facility and they require barcode scanners as you mentioned I am assuming that it will be filled with rows to tiered shelving and not just a big open space?   If there are rows of shelving then yes you would need a few AP's if its open plan you could get away with less. Also with most warehouses being made of sheet metal the signal is going to bounce around like crazy inside so fine tuning the radios power is going to be required.    Good luck and hope it all goes well.  ... View more

Sometimes making clients roam when an AP is overloaded can cause this.  You can check the event log to see if the APs are asking phones to roam because of load.   You can read about client load balancing here: https://documentation.meraki.com/MR/Other_Topics/Client_Balancing   You can disable load balancing in the RF profile: https://documentation.meraki.com/MR/Radio_Settings/RF_Profiles   ... View more

Route based is the Default in Azure Just click on your Dashboard and search for "Virtual Network Gateways"  click ADD Choose your subscription, name the gateway, make sure you choose correct region and put the gateway in same resource group as your Vnet (keep it easy).  SKU can be standard or VpnGw1 << is better than you can modify later. under Virtual Network choose the Vnet you want to put the VPN on. Create new public IP and wait for like 20 minutes it takes a bit. you will have to create a Root Certificate and User Certificates for IKE SSTP this one is tricky to manage if you want a cert for each user.  There are guides out there but its not difficult to setup. I configured mine for Radius Authentication. FYI policy based is the IKE_v1 we dont want that !!!   ... View more

Issue required reconfig on PBX, UNITE and something called an Xgate.      Ascom I62 rely heavily on DTIM, meraki being default of 1 killed battery life.   ... View more