Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About Grant3779

Re: Ping through MX Interface to IP on different Interface

by in Security & SD-WAN
‎Feb 20 2020 7:16 AM
‎Feb 20 2020 7:16 AM
Thanks for testing this both. Means i can setup an IPSLA LAN side on my Cisco kit for this. ... View more

Ping through MX Interface to IP on different Interface

by in Security & SD-WAN
‎Feb 20 2020 1:26 AM
‎Feb 20 2020 1:26 AM
Hi All,   On the ASA you are unable to ping an Interface IP if the icmp traffic comes in via another interface. This is by "design"   Is this also a design of the Meraki MX appliances? I haven't managed to test this yet.   I'm "hoping" I can send a ping to the MX Internet / WAN address but the source of the ICMP would be from a LAN device behind another interface on the MX.   (Correct routing would all be in place).   There is a specific reason I am looking for this ability 🙂 Thanks ... View more

Re: Order of Switches - Switches / Switch Stack

by in Switching
‎Jan 17 2019 11:16 AM
‎Jan 17 2019 11:16 AM
Hi All, Well.... I had a typo in my switch name, one single character which indeed made 203 first based on alphabet 🙈. Thanks for the replies. You were right 😎. I only noticed the typo. ... View more

Re: Order of Switches - Switches / Switch Stack

by in Switching
‎Jan 16 2019 12:44 PM
‎Jan 16 2019 12:44 PM
Hi C Miller,    Yes Pretext exactly the same. I had just blanked those out to respect the company tbh, no other reason, but everything is the same apart from the numbers. The 203 has the lowest IP so i do think this is it. Not tested yet though.  ... View more

Re: Order of Switches - Switches / Switch Stack

by in Switching
‎Jan 16 2019 2:35 AM
‎Jan 16 2019 2:35 AM
Just had a thought and will check it out later. It may list the stack in that dashboard area in order of their IP address. Lowest IP first and so forth. I had to move a switch to this stack and that has a lower IP address which is why it may show at top. I usually keep them sequential if I can. Not sure if anyone is able to test this in a lab? I think this is it though ... View more

Order of Switches - Switches / Switch Stack

by in Switching
‎Jan 15 2019 12:23 PM
‎Jan 15 2019 12:23 PM
Hi,   New to Meraki. Cisco CLI guy 🙂   I have a 3 switch stack and when looking at the dashboard it is displayed as the attached. Is there a way I can amend the layout so it shows 201 at top, 202 in middle, 203 at bottom. This is how they are racked and stacking cables connected in relation to that also. My dashboard image shows 203, 201, 202 in that order but that isn't physically how they are. Is this just cosmetic? Doesn't seem to be a role such as stack master etc.. compared to Cisco stacking, or switch numbers. Not that I can see anyways.   I would just prefer for switch 201 to be listed first, especially when going into "configure switch ports" for the stack as currently the ports begin   203 /1 203 /2 203 /3   etc..       Hopefully that makes sense. ... View more
© 2024 Cisco Systems, Inc.