Hi, I'm setting up a new office with approx 40 users. The FW will be an MX64, LAN switching will be HP stacked switches. There will be 4 VLANs, Management, Data, Voice and Guest WiFi. VLAN management will be done via the HP core layer 3 switches. There will be 2 MR APs for WiFi. WAN connectivity will be DSL using PPPoE with the BT smart hub in bridge mode. I will need to setup a site to site VPN to our core network at a hosted DC which will terminate on a Cisco ASA router. All corporate networking services will be delivered via the VPN e.g. DHCP, DNS, AD, internet access, etc. All guest WiFi traffic will be routed directly out to the internet. I've experience of setting up HP switching, MR APs but not on using an MX as the firewall. Our other sites are connected via a VPLS network using managed Juniper routers. This is a temporary office so will be setup a bit differently to our other permanent sites. My thoughts are: 1. Disable VLANs on the MX. 2. Set the default route from the HP core switch to the MX IP. 3. Set static routes on the MX to VLANs. Any help/advice appreciated. Thanks, Paul.
... View more