Hi. Im using an Go Gx20 with WiFi 6 over the built in Poe and notice a higher power consumption compare to old all in one hardware. Is there any settings planed where it’s possible to turn down power consumption as off hours or specific settings? ... View more

Hi Our MX84 in HA mode where upgraded to 16.16 a couple weeks ago. Since then there is now and then a brief period loos of connectivity with underlaying switch stacked par. The switch HA connected as fully redundant switch stack. I have tested ping from a computer. During outage there is ping lost, the period is less then 1 min. So it´s no reboot of the switch. ... View more

Hi    I´m working with a small customer and we are looking to a simple switch port protection. We don´t have any layer 1 connection to the ports that isn’t used in the building.  But we would like to have a simple MAC port protection against changing of device.   The function Sticky MAC seem interested. You can apply the feature per port, put a allow value and let the and system monitor for a couple days. Check the mac addresses connected to the port. Change allowed value and give a name on the devices connected to the port.   Anyone who can share experiences. Good or bad… How does it work with a hub?   Best Regard Daniel ... View more

Hi I am about to upgrade a couple of MX84 to 15.42.1. But I can se following regression. What exactly does this mean? Will I not be able to access local settings through cable? Due to an MX 15 regression, the management port on MX84 appliances does not provide access to the local status page. ... View more

Hi   Since a couple week back there have been multiply alarms a day regarding IP conflicts. The device causing this is Apple Phones. Could it have to do with the new iOS 14 MAC address function?  What to do? I don´t want to turn of the alarm. Meraki working on a fix for this? The alarm should automatically be ignored by the system if it´s not a error.     To reduce this privacy risk, iOS 14, iPadOS 14, and watchOS 7 include a feature that periodically changes the MAC address your device uses with each Wi-Fi network. This randomized MAC address is your device's private Wi-Fi address for that network—until the next time it joins with a different address. ... View more

Hi,   I´m about to setup a HA Warm Spare. I have some questions regarding the steps. I have multiply public IP addresses, so no problem with VIP configuration.   Today I´m using public IP address x.x.x.162 on the MX1-WAN 1 port and there is some default port forwarding rules associated with same IP.   The new MX2 Warm Spare WAN 1 will be configured as address x.x.x.166 and initaly use MX uplink IP.   What is the best next step to proceed?   Should I start to change IP address on MX1 and WAN 1 to new address x.x.x.165. And then change MX 2 uplink IP to use virtual IP and put in x.x.x.162 as VIP   Or   Should I first change MX 2 uplink IP to use virtual IP and put in x.x.x.162 that is already used by MX1 WAN 1 and then change MX 1 WAN 1 to address x.x.x.165.   And the second question….   I guess the already configured default forwarding rules will then be associated used with when virtual IP is set as x.x.x.162? ... View more