Community Record
7
Posts
0
Kudos
0
Solutions
Badges
What if the access switches are stacked to look like one and the traffic is spanned from all the switches in the stack to a single port on the switch stack. Can that be possible.
... View more
Dear community, Is there a way to use remote span on meraki switches. Also can Meraki core switch get span data from other switches.
... View more
Sep 5 2018
6:32 AM
Thank you. the Switch is now connecting to the cloud. I put the uplink in the IP range of the firewall and made the firewall the default gateway.
... View more
Sep 5 2018
5:22 AM
by this "you need to set this to an ip and gateway in the subnet of your upstream link." you mean i should use an ip address from the uplink to the firewall device?
... View more
Sep 5 2018
5:13 AM
Yeah they both have IP addresses from the 172.16.15.0/24 network with 172.16.15.3 being the gateway. the firewall device can ping the gateway interface 172.16.15.3 on the MS 350. I even changed from static IP address to DHCP on vlan 15 to see what will happen, and nothing is changing.
... View more
Sep 5 2018
4:57 AM
I don't think the firewall is blocking anything because there is a MS 250 switch connecting to the MS 350 core switch and the meraki box has access to the internet. There is connection THROUGH the box, but the box is not connecting to the internet.
... View more
Sep 5 2018
3:08 AM
Dear Community, I have a network setup using MS 350 for my core switch and MS 250 for access switch. my ISP connection is terminating on a cisco 2960 switch, from there the internet connection is connecting to a firewall device and then to my core switch on an access port. the challenge i have right now is that my core switch is not connecting to the meraki cloud but there is access through the switch because the configurations have been downloaded onto the switch. kindly help.
... View more
