Hi! I'm still new to Meraki and just wanted to get some advice for some new Hardware.   I have 2 offices, the HO office where I am and then the remote office.   We are moving the remote office to a new location, and for the new location I've bought the MS125 and two MR44s.  The new location internet will not be installed until Nov 1st or about two weeks from now.   I haven't added the new Meraki hardware to my dashboard yet.  I would like to setup the new hardware at my HO and then move them to my Remote office when the internet is almost ready.   I'm worried when I go to deploy the new HW, it won't work because I set it up at my HO already.   So should I register the new hardware right now and test it at my HO?  Or should I wait until I can take them onsite to where they will be installed ? I'm leaning to getting all done at my Head Office and once they are registered (claim the order etc) it won't matter where they are installed.   Any advice would be appreciated!   Thank you! ... View more

Hi, I have a Meraki switch that I would like to utilize the bandwidth to my Meraki  AP. The AP is a MR44, and it can do 2.5G BASE-T Ethernet (RJ45).   My switch is MS125 with 48x1GbE RJ45 and 4x10 GbE SFP Fixed. Is there a 2.5Gbps Copper Transceiver that I can put in there so my AP can fulfill it's potential?  Or do I have to use a 10Gbps Copper transceiver and it auto negotiates down to 2.5? Or am I stuck with connecting it to my 1 GbE copper ports?   Any help would be appreciated.   Thank you!   ... View more