有線の802.1x認証においてダイナミックVLANに落とすことができません。 Merakiの設定が誤っているのかRadiusの設定が誤っているのか分かりません。 分かりやすいドキュメントはないでしょうか？ ... View more

I was thinking about a configuration in which the MX450 would house a PPPoE line. However, when I connect it to the ONU with a LAN cable, it doesn't even link up. I tried connecting with a straight cable, connecting with a cross cable, changing the cable, restarting the MX450, and restarting the ONU, but all efforts failed. Is there a problem with the configuration of directly accommodating a PPPoE line on the MX450? ... View more

When using BGP on MX, is it possible to adjust the MD value? I can't find any documentation that describes this. ... View more

I cannot access the local status page of the MS120-8 that I have set up. ① Assign an IP address to the MS120-8 via DHCP ② Check connectivity on the Meraki dashboard ③ Change the IP address of the MS120-8 to Static   Example) IP address: 192.168.1.10 Gateway: 192.168.1.1 DNS: 8.8.8.8   Connect the PC directly to the MS120-8. Accessing the following from the browser is also NG. (Ping communication is possible from PC to MS120-8 (192.168.1.10)) 　http://192.168.1.10 　setup.meraki.com 　switch.meraki.com 　my.meraki.com   I used the following site as a reference for the initial setup, but I was unable to access the local status page from the start.   ■MS120-8 Series Installation Guide https://documentation.meraki.com/MS/MS_Installation_Guides/MS120-8_Series_Installation_Guide   ■MS120-8FP unable to locally connect https://community.meraki.com/t5/Switching/MS120-8FP-unable-to-locally-connect/m-p/222421   ■MS120-8P switch problem https://community.meraki.com/t5/Switching/MS120-8P-switch-problem/m-p/36484   ■Accessing the Local Status Page https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Meraki_Device_Local_Status_Page ... View more