Meraki

Stef_Thumser · ‎Aug 16 2018

Thanks for explaining, have to look for a different solution for our network now. Was seriously thinking about getting a MX65W. Spares me the trouble of beeing not able to use the full bandwidth. Regards, Stef

Stef_Thumser · ‎Aug 16 2018

Problem solved, thanks everyone for their efforts ! The problem was that even if sitting on it it only produced 40Mb/s on client and on the MR33 itself. Which was a lot different right after initializing the device for the first time. Checked all the proposed settings, set Vlan from "0" to nothing but with no result. No traffic shaping or firewall rules established. Ended up resettting to factory defaults, again Vlan to nothing and now its working just fine. Radio settings on max. Strange enough it took about 15 minutes to reinitialize including temporarily vanishing of the SSID and beeing unable to reconnect by occasion. Seems like there was more to do than just restart?! Troughput now 250/40 Mb/s on client and 210Mb/s on the MR while "sitting on it" with 1GB PoE injector and Netgaer 4port unmanaged up second floor. First floor still 140Mb/s. Basement 80Mb/s. I am fine with that, now to see if there is a cure for that MX65W which is unwilling to do more than 250Mb/s. Regards Stef

Stef_Thumser · ‎Aug 15 2018

Forgot to thank you for replying, apologies!

Stef_Thumser · ‎Aug 15 2018

Didn´t work unfortunately. Thanks for your efforts

Stef_Thumser · ‎Aug 15 2018

I try to be a little more specific: MR33 is plugged in in an unmanaged 4-port Netgear switch en powered by an PoE injector as I am testing it on my office desk ;-). LAN speed (also behind this switch!) and in network is about 300-400Mb/s but the MR33 only produces (now) about 100Mb/s. It is use it in Dual band operation mode with Band Steering which made it a bit faster. From 40 to now 100Mb/s. Radio settings: 2.4GHz channel; auto/target power 16 5.0GHz channel, auto/target power 26 Both default indoor profile Client IP ass uses NAT Mode, no VLan tagging nor content filtering rules or any sort of traffic shaping used. Hope this helps

Stef_Thumser · ‎Aug 15 2018

Thanks for answering. Unfortunately I have to use both frequencies simultaniously so that is not an option. Every simple router for much less can handle this. I am sure the MR33 can, too. Hopefully I can figure it out or someone else can help. Not sure if this isn´t a PoE issue or a problem with an unmanaged "rogue" switch ;-). Shouldn´t be but who knows...

Stef_Thumser · ‎Aug 15 2018

Throughput varies from 40 mbps to 240 mbps without changing settings. Anyone suggestions how to set radio and/or channels for max. throughput ?

Meraki

Community

About Stef_Thumser

Stef_Thumser

Community Record

Badges

Re: MX 64/65 throughput???

Re: MR33 AP

Re: MR33 AP

Re: MR33 AP

Re: MR33 AP

Re: MR33 AP

MR33 AP

Re: MR33 AP