Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Abdullah_Pracha
Abdullah_Pracha
Comes here often
Member since Jun 25, 2024
Friday
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Friday
I did opened a case, but they asked to do the layer1 stuff first which I did. If this is a hardware issue then why the new one switched to repeater mode? and the older one started working.
... View more
Friday
Hey All, My MR AP(CW916I) device switched to repeater mode. I rebooted it, but it remained in repeater mode. I replaced it with an identical MR, which worked fine on the same port. I then tested the original MR on another port in the network closet, but it still wasn't working and stayed in repeater mode. The next day, the new MR I had replaced switched to repeater mode, while the old one obtained an IP address and started working. Does anyone ever got a same issue?
... View more
Wednesday
is there any guide where I can find how to configure it in standalone mode, I think a separate network would be created for each of them
... View more
Tuesday
Yes, they are running in HA (warm spare). So if I split and run them in standalone mode I wouldn't be able to get redundancy. Also how can I configure them in standalone mode?
... View more
Tuesday
I want to setup my MX-250 hubs in active-active mode. Currently the throughput on one hub maxes out occasionally, causing issues. Is it possible I can split my spokes on each hub?
... View more
© 2024 Cisco Systems, Inc.
