Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Rujag
Community Record
7
Posts
4
Kudos
0
Solutions
Badges
Bad cabling works at play. We try to use another cat6 cables and plug it directly to the switch. It's working well right now.
... View more
right now is 30.1 but i think I found the issue. bad cabling works. damn
... View more
Jun 8 2024
2:05 AM
But the problem is, we cannot powering up the MR57 AP since they only got power below the requirement right now.
... View more
Jun 7 2024
9:53 PM
I'm using cat 6. and all device is using latest firmware. but the MR57 is not discovered. Also FYI I just plug 1 MR57 so there should be much power available. Only when I try to use additional PoE injector the AP can go up normally.
... View more
Jun 7 2024
9:46 PM
the MR57 is not discovered. we think its because MR 57 is requesting 30W but the MS125 only delivered 12,5W
... View more
Jun 7 2024
8:48 AM
I'm using port 43 to power 1 unit mr57. It's written 12.5w (PD requested 30w). Is there any thing I should change in the setting?
... View more
Jun 7 2024
8:36 AM
Please forgive me if this is very basic. But I cant seems to enable ms125 48lp to power 30w device (the port only provide 15w max) eventhough there is still much power available. Where can I configure it? Thank you.
... View more
Labels:
- Labels:
-
Other
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 1480 | |
| 2 | 1483 |
© 2024 Cisco Systems, Inc.
