Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Rujag
Community Record
7
Posts
4
Kudos
0
Solutions
Badges
3 weeks ago
2 Kudos
Bad cabling works at play. We try to use another cat6 cables and plug it directly to the switch. It's working well right now.
... View more
3 weeks ago
2 Kudos
right now is 30.1 but i think I found the issue. bad cabling works. damn
... View more
3 weeks ago
But the problem is, we cannot powering up the MR57 AP since they only got power below the requirement right now.
... View more
3 weeks ago
I'm using cat 6. and all device is using latest firmware. but the MR57 is not discovered. Also FYI I just plug 1 MR57 so there should be much power available. Only when I try to use additional PoE injector the AP can go up normally.
... View more
3 weeks ago
the MR57 is not discovered. we think its because MR 57 is requesting 30W but the MS125 only delivered 12,5W
... View more
3 weeks ago
I'm using port 43 to power 1 unit mr57. It's written 12.5w (PD requested 30w). Is there any thing I should change in the setting?
... View more
3 weeks ago
Please forgive me if this is very basic. But I cant seems to enable ms125 48lp to power 30w device (the port only provide 15w max) eventhough there is still much power available. Where can I configure it? Thank you.
... View more
Labels:
- Labels:
-
Other
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 396 | |
| 2 | 399 |
© 2024 Cisco Systems, Inc.
