Community Record
4
Posts
9
Kudos
0
Solutions
Badges
a week ago
I am having the same issue on MR46 models as well and it was happening on firmware 30.7 so we tried updating to MR 31.1.5.1 but no change. Also tried rebooting APs and powering of Cisco POE switch ports for 5 minutes no change. The only thing we have not tried yet is a factory reset of an impacted AP as they are on remote sites. If anyone can try that and let me know if it has any impact.
... View more
Nov 18 2024
3:53 AM
I have the same issue with some MR46 and MR76 access points since upgrading to MR30.7 firmware weeks ago. The access points have been in place for a long time with no issues. I am going to try upgrading to MR30.7.1 just released though I did have success in shutting down the switch port for a MR76 with the issue for 3 minutes and when I open the port and the access point initialised it was back up to 1Gb full duplex connection again.
... View more
Nov 1 2024
2:25 AM
2 Kudos
I have had this error on 5 x MR46 access points, I only upgraded to firmware MR30.7 a few weeks ago. This is the 1st time I have seen this error and the APs have been in place for years. I tried flapping the switch port on 1 AP and left it off for 2 minutes, but still have the same problem. POE on the switch port is drawing 30W class 4. I do not think it is a cabling issue to see it on so many APs in a short period.
... View more
May 17 2024
6:14 AM
7 Kudos
I once had a customer complain “the network is causing me pain” So I logged onto my Meraki Which is accurate, never whacky And proved it was the laptop again.
... View more
My Top Kudoed Posts
Subject | Kudos | Views |
---|---|---|
7 | 8782 | |
2 | 5125 |