Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Baam
Community Record
11
Posts
2
Kudos
0
Solutions
Badges
Jun 18 2024
6:32 PM
Thanks to you. Meraki Support recommend to update the firmware. Now the speed test for MX450 through WAN health is now tally. The speed test by user is slow due to AP is in low power mode. Changed the PoE to 802.3at (25W) and the AP is now working properly.
... View more
May 12 2024
1:52 PM
Thank s for the recommendation. Will try again later.
... View more
May 10 2024
10:40 AM
Thanks for the suggestion, will do right away, and update the case. Thanks!
... View more
May 10 2024
10:39 AM
the MR33 is set to 40mhz
... View more
May 10 2024
10:28 AM
2 Kudos
Already tested from a Laptop connected ISP Router, able to get 800mbps, here is the screenshot
... View more
May 10 2024
10:25 AM
Thank you for the suggestions. it turns out weird. both speeds does not match. is it a bug or got another explanation here?
... View more
May 10 2024
10:19 AM
my side still pending to test the speed test using laptop directly connected to MX450. will update later once tested. do you have any suggestion? i could try them also
... View more
May 10 2024
10:13 AM
Here, take a look at this screenshot. i just re-run again the speed test. It is more weird because now is midnight here and no one use the network. but the speed still not satisfying
... View more
May 10 2024
10:11 AM
Here is the screenshot of it, am i configure correctly?
... View more
May 10 2024
9:46 AM
tested. same only able to get around 300 to 400mbps
... View more
May 10 2024
9:39 AM
Hi Everyone, need your help/suggestion/recommendation. I got 2x800mbps ISP uplink. Tested via laptop to both ISP Router is able to get 800mbps. However, after installed the MX450 into the network, the speed get by the user is around 300 to 400mbps (tested multiple time a day). Which is quite weird. No traffic shaping is applied. Checked via WAN Health and Dashboard Throughput is also getting 300 to 400mbps. WAN1 / WAN2 > MX450x2 > 2960 > MR33 Anything that I miss or need to check?
... View more
Labels:
- Labels:
-
Other
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 2026 |
© 2024 Cisco Systems, Inc.
