About JohnGeorge

JohnGeorge · ‎05-29-2020

Swag, did someone say swag? Attending Cisco Live with your favorite beverage from your home! Win.

JohnGeorge · ‎05-13-2020

Please don't tell my wife that I am folding at home, let's just keep this our little secret - shall we ?.?.

JohnGeorge · ‎04-07-2020

@Nolan Verizon was telling me that the IMEI is not recognized? Anything special that you had to do to get it working? Static IP. etc. ? Thx!

JohnGeorge · ‎04-07-2020

My Woe Story - MG21E = woes for me with Verizon, so I end up using the inSeego DS USB Modem on the MX64 They didn't recognize the IMEI, blah blah.... *Edit* The most important factor! This does not require PoE injector, so this means rebooting the MX also reboots the modem! So here comes the .... https://www.inseego.com/solution/skyus-meraki/ It just works and flawlessly using the USB port. Pros Powered and connects via the USB port 25-30 Mbps to the device with crudy LTE service inside the IDF No PoE Injector 2 SIM Cards Damn small form factor Cons Powered and connects via the USB port ->Speeds limited by USB There are caveats like NAT, Port Forwards, etc., but this works great when Internet access is just needed.

JohnGeorge · ‎03-30-2020

Thank you for your test setup. In these odd times of WFH, this may be an easier setup than a full blown MX,MS,MR. The Z series and W series don't support the radius attributes for Vlan assignment, which stinks.

JohnGeorge · ‎03-30-2020

Sweet! Can you tell me what hardware you're using at the spoke sites? I really this this would make an awesome setup for a remote (wireless) site. Are there any gotchas with this? If this works, this would make for a very light roll out to support micro/small wireless deployments.

JohnGeorge · ‎03-30-2020

Crowd sourcing time! Has anyone done this? https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/SSID_Tunneling_and_Layer_3_Roaming_-_VPN_Concentration_Configuration_Guide I am thinking that the MR33 (Wall Power) or MR30H PoE (both spokes sites) and sizing the OAC MX (Hub) would be a pretty slick configuration. I just have not seen anyone doing this setup, for all wireless deployments - this would be a great, budget friendly solution. Thanks for your time! John

JohnGeorge · ‎03-25-2020

Just for giggles, swap the AP connected 100mbit with one of the known working at 1000mbit using that same cable. See if the problem remains, follows the AP, etc. If you know that the switch port is good, it has to be one of these -> AP, cable(s) or PoE injector. Process of elimination to find the winner!

JohnGeorge · ‎03-25-2020

So complying with the mandatory "stay put" that the Gov. in Michigan has issued during the Zombie Apocalypse, have you played around with your Meraki Lab and came up with some "creative" WiFi names? So far.... (top 5) 1. Please reboot. 2. Connecting... 3. Loading... 4. Unable to connect to the Internet. 5. Enter your username Sorry, going stir crazy over here. If humour is not required, you can skip Window 1 and continue on your way. Please remember, don't sweat the petty things and don't pet the sweaty things. JG

JohnGeorge · ‎03-24-2020

I am in Michigan and its still cold outside, the socks could be dual purposed as hand and feet warmers. Side note, working at home I won't have to wear those pesky shoes that hide them.

JohnGeorge · ‎02-04-2020

In the words of AvE, "I think this needs more chooch, not to be confuzzel'd with chaach." Spanks for watching!

JohnGeorge · ‎01-09-2020

2020 New Year's Resolutions Get my new hardware installed, I am thinking probably titanium because they don't install terminator hardware yet. Abuse to the MG-21 to the fullest potential during the trail. Beg, borrow, steal, or bribe a seat in ECMS. Utilize my college/CEU to the full potential. Save MORE cash for retirement. API, API, API - use the Meraki API MORE! Keep one nostril above water.

JohnGeorge · ‎10-22-2019

Man, I wish that this stuck to the fridge. Different type of magnet.

JohnGeorge · ‎03-14-2019

Hello from Detroit. I love the easy lift of Meraki to design, deploy, and support entire networks.

JohnGeorge

Community Record

Badges

Re: Meraki at Cisco Live! Pull Up a Chair and Imagine What is Possible!

Re: Community Challenge: Folding@home

Re: MG21E on a food truck

Re: MG21E on a food truck

Re: MX Split Tunneling VPN with MR30H/MR33

Re: MX Split Tunneling VPN with MR30H/MR33

MX Split Tunneling VPN with MR30H/MR33

Re: Why only 100 mbit on one device.

Humor - So, bored WFH? What funny SSIDs have you recently created?

Re: Spend some WFH time here on the community, earn points and win prizes!

Re: Announcing Lift-Off Badges!

Re: Happy New Year! What are your Networking Resolutions?

Re: Time for a survey — and another chance to snag swag!

Re: Announcing Lift-Off Badges!

Humor - So, bored WFH? What funny SSIDs have you recently created?

Re: Spend some WFH time here on the community, earn points and win prizes!

Re: Announcing Lift-Off Badges!

Re: Meraki at Cisco Live! Pull Up a Chair and Imagine What is Possible!

Re: Why only 100 mbit on one device.