Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About vijaykumar
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Jul 4 2024
9:04 AM
Thanks for your response. I will test it in MW and monitor it. Thanks again.
... View more
Jul 4 2024
9:00 AM
Hi Jimmy Thanks for your response. I have planned to correct the missing VLAN on switch side and MX LAN in MW. I will monitor post changes and let you know.
... View more
Jul 4 2024
8:48 AM
LAN port config is as below.
... View more
Jul 4 2024
8:45 AM
If I remove Native VLAN on MX, will it cause any outage ?
... View more
Jul 4 2024
8:44 AM
MX running on MX 18.107.2.
... View more
Jul 4 2024
8:11 AM
Hi All, I have a situation where MX spare device is calming to be as master for 2-5 second and then going to spare mode. Primary remains Master. I can see VRRP events in event logs. On Nexus device we can see MAC flap for MX device. There is no error on Physical port switch connecting towards MX. Log from the switch: Jul 4 09:28:39.869: %SW_MATM-4-MACFLAP_NOTIF: Host cc03.d9ff.706d in vlan 203 is flapping between port Gi2/0/3 and port Gi1/0/3 Jul 4 09:31:15.931: %SW_MATM-4-MACFLAP_NOTIF: Host cc03.d9ff.706d in vlan 203 is flapping between port Gi2/0/3 and port Gi1/0/3 Jul 4 09:31:27.801: %SW_MATM-4-MACFLAP_NOTIF: Host cc03.d9ff.706d in vlan 207 is flapping between port Gi2/0/3 and port Gi1/0/3 Jul 4 09:31:59.691: %SW_MATM-4-MACFLAP_NOTIF: Host cc03.d9ff.706d in vlan 203 is flapping between port Gi2/0/3 and port Gi1/0/3 Could you please suggest what else we can check in this to make VRRP stable.
... View more
Jun 28 2024
8:30 AM
Thanks for your response. Just to understand in more detail, If I remove 4 VLAN out of 5 from L2 switch trunk port, leave only one VLAN passing through trunk, in this case also Primary MX will remain Active? I am just trying to compare it with HSRP working. In case of MX HA Pair, How LAN devices [Host machine] will decide to send Data to Which MX? I mean who they will get ARP?
... View more
Jun 28 2024
7:27 AM
Hello All, I want to understand MX HA Pair in routed mode where we have 5 VLAN configured on MX device. These 5 VLAN are configured & passed in L2 switch connected in LAN port of Both MX. As per the Meraki Documents, It sends VRRP message for each VLAN in LAN segment and when Spare device does not receive these messages within certain time, It will take over active Role. My doubt is, If I remove certain VLAN from intermediate L2 switch, in that scenario, Spare MX will not receive VRRP message. Will Spare MX work as Active device in HA for removed VLAN?
... View more
© 2024 Cisco Systems, Inc.
