That has been done already, users experiencing this only on Intune machines and this SSID (certificate authentication). It happens randomly and reconnects in few seconds.   ... View more

Do you have client load balancing and/or bandstearing enabled?  Try shutting it off for a day.  I found that was my problem.  There is actualy a known defect for client balancing.  I disabled that and 2.4 Ghz and it's been very smoooth since.   It may be fixed int eh most recent release, but I cannot confirm.       ... View more

Go to the switch, click on the port and look at the clients. If the client is a bit more silent then you could go to the mac-address table in the tools page and filter on port. In the extreme case you have very quite clients you could add port-security sticky to that port and just see after a while what mac addresses were added on the port. ... View more

I'd look into SNMP polling and Netflow. Is there a specific design goal or business use case that you're aiming to achieve? I expect that most Meraki networks would experience mostly north-south traffic so MX monitoring might address some of the utilization monitoring needs. https://documentation.meraki.com/General_Administration/Monitoring_and_Reporting/SNMP_Overview_and_Configuration https://documentation.meraki.com/General_Administration/Monitoring_and_Reporting/Meraki_Device_Reporting_-_Syslog%2C_SNMP%2C_and_API ... View more

The switch will also attempt to use DHCP over alternate VLANs, in order to obtain IP config and reach the Dashboard that way (it will then flag up that it's using that, rather than the configured VLAN). If your Core switch is configured for Layer-3 routing, remember that the management is separate from the user traffic (different VLAN)   https://documentation.meraki.com/MS/Layer_3_Switching/MS_Layer_3_Switching_and_Routing#Switch_Management_IP_and_Layer_3_Interfaces ... View more