Still struggling with this. Cloning the existing network seems to work ok, but after adding the new MX105 & 3 unconfigured switches to the new, cloned, network, the 3 new switches go dormant or offline. I'm assuming this happens because the config on the MX105 has changed and the IPs it was assigning the switches are no longer in the right DHCP scope the MX105 inherited from the clone. The newly cloned MX105 also won't give out IPs in the cloned scope to the switches or even a laptop plugged directly into a LAN port on the MX105. Not sure what's going on here.   Also weird: removing the MX105 from a network and trying to do a factory reset doesn't work. It retains the static IPs one would assign in the local config page. And I can only get to the local config page by hard coding my laptop NIC to 192.168.0.x ... View more

There's a bit of problem with this.  The firmware page shows the most recent Stable release as 18.107.2.  A newer version of 18.107 is buried in the Other available versions section at the end.  Stable patches used to be visible in the Stable section.  In fact, the organization of the tabs has been recognized as declining in stability from left to right (Stable > Stable RC, Beta).  The label Other available versions communicates "don't look here unless you know what you are doing". ... View more