Community Record
6
Posts
0
Kudos
0
Solutions
Badges
Mar 4 2025
4:51 PM
Thank you Mr GreenMan for your input and advise. This definitely helps alot in our direction.
... View more
Mar 3 2025
4:24 PM
Hi Greenman Thank you for your advice, this is a good start. So, from my understanding if we decide to stay on premise then we will still have to go with the hardware controller to manage my existing C9120AXI AP model. With the new hardware controller, we also have the option in the near future (as long as the model is not EOL) to monitor this hardware controller in the Meraki dashboard? The other way around is to redesign the whole wireless environment by bringing in the proper MR-AP model and run the setup and configuration in the Meraki dashboard?
... View more
Mar 2 2025
10:49 PM
Hi All I have a Cisco Embedded Wireless Controller on Catalyst Access Points running on ISO version 17.9.4.27 The AP model been registered to the EWC is C9120AXI-K We are looking at licensing it the devices and migrating them over to Meraki. I am currently looking for some guide or advises if anyone has done this before? Thank you very much for time and attention!
... View more
Feb 13 2024
9:21 PM
Hi Just disable all the BPDU guard from the STP setting and it works! both link are up and running now
... View more
Feb 13 2024
7:38 PM
So what will be the best recommendation for dual uplink? loop guard with UDLD enforced or nothing at all?
... View more
Feb 13 2024
6:36 PM
Hi All Network Guru. I have just setup 3 stacked MS225 switches and it has a single uplink to a FS core switch. I decide to setup a dual uplink for redundancy purposes and so I went ahead and configured 2 aggregate port on the Meraki (port26 on switch27 and port 49 on switch 29) and FS end. But as soon as I switch from the single uplink and connected to the aggregate port on the Meraki end, the entire stacked went offline. I am wondering if this is because BPDU guard is enable on the Meraki end? I am trying to get some idea where I can start troubleshooting and what is likely the cause of it so any pointers will be greatly appreciated! Whereas Over at the FS end I realize that the BPDU guard is disable I read from the community forum and I understand that for uplink it is better to enable loop guard instead, as BPDU guard are enable on the access and client end to prevent spanning tree
... View more
