Meraki is correct, here is this part of the IEEE table: Association status codes Status code Meaning 0 Successful 1 Unspecified failure 2 Tunneled direct link setup (TDLS) wakeup schedule rejected but alternative schedule provided 3 TDLS wakeup schedule rejected 5 Security disabled 6 Unacceptable lifetime 7 Not in same basic service set (BSS) 10 Can't support all requested capabilities in capability information field 11 Reassociation denied due to inability to confirm that association exists 12 Association denied due to reason outside scope of this standard 13 Responding station doesn't support specified authentication algorithm 14 Received authentication frame with authentication transaction sequence number out of expected sequence 15 Authentication rejected because of challenge failure 16 Authentication rejected due to timeout waiting for next frame in sequence 17 Association denied because AP unable to handle additional associated stations 18 Association denied due to requesting station not supporting all data rates in the BSSBasicRateSet parameter, where BSS refers to basic service set 19 Association denied due to requesting station not supporting short preamble option 20 Association denied due to requesting station not supporting packet binary convolutional code (PBCC) modulation option 21 Association denied due to requesting station not supporting channel agility option 22 Association request rejected because spectrum management capability required 23 Association request rejected because of unacceptable information in the power capability element 24 Association request rejected because of unacceptable information in the supported channels element 25 Association denied due to requesting station not supporting short slot time option 26 Association denied due to requesting station not supporting direct sequence spread spectrum orthogonal frequency division multiplexing (DSSS-OFDM) option 27 Association denied because requesting station doesn't support high throughput (HT) features 28 Pairwise master key (PMK-R0) Key Holder (R0KH) unreachable 29 Association denied because requesting station doesn't support phased coexistence operation (PCO) transition time required by the AP 30 Association request rejected temporarily; try again later 31 Robust management frame policy violation 32 Unspecified. Quality of service (QoS)-related failure 33 Association denied because QoS AP has insufficient bandwidth to handle another QoS station 34 Association denied due to excessive frame loss rates or poor conditions on current operating channel, or both 35 Association (with QoS BSS) denied because the requesting station does not support the QoS facility 37 Request declined 38 Request not successful as one or more parameters have invalid values 39 Traffic stream (TS) not created because request can't be honored; however, suggested traffic specification (TSPEC) provided so that the initiating station may attempt to set another TS with suggested changes to TSPEC 40 Invalid information element (doesn't follow 802.11 standard) 41 Invalid group cipher 42 Invalid pairwise cipher 43 Invalid authentication and key management protocol (AKMP) 44 Unsupported robust security network element (RSNE) information element version 45 Invalid RSNE information element capabilities 46 Cipher suite rejected because of security policy 47 TS not created; however, hybrid coordinator (HC) may be capable of creating TS, in response to a request, after the time indicated in TS delay element 48 Direct link not allowed in the BSS by policy 49 Destination station not present within this BSS 50 Destination station not a QoS station 51 Association denied because ListenInterval too large 52 Invalid fast transition (FT) action frame count 53 Invalid shared key (pairwise master key identifier or PMKID)
... View more
