I think my replacement PSU was the one you had... The old one I had was smaller and I think the make started with Chang... I can't tell if your new is that, of a third variant?
... View more
In the new look administrators page, you can create limited managers like 'switch port manager's or 'camera footage and sensor'. Are any of those roles any good for you?
... View more
I had one of those smaller (more powerful) transformers with the RMA replacement I had for a loose power connection. Are your new PSUs more powerful?
... View more
Why do the guest users need to access the internet from the central site? I've usually just sent them out of the local site with corporate users going via a central site where it can be better controlled.
... View more
@Kenny_M8 why do they need static management addresses? Old style syslog server or authorisation servers? If you can set them up as a set couldn't you have all the addressing with only the MX WAN being 'wrong' at this point?
... View more
I always go with your first architecture, but replace the MS130s with unmanaged Cisco layer 2 switches. Cheaper, simpler, can't be hacked and do the job. At their price you can always have a spare onsite.
... View more
1.1.1.1 is also the IP that a lot of Meraki devices use when rebooting before getting a DHCP address. I've no idea why, but when I reboot switches the APs all seem to briefly send as this...
... View more
1) Claim the devices and serial numbers into your organisation 2) Add the devices to your network 3) Create one or more SSIDs with authorisation methods etc. 4) Plug in the devices 5) Connect to the SSID There are many more configuration steps that you can do, but essentially that will get you started.
... View more
Indeed, the 18.x firmwares in particular have had this problem. The 19.x firmwares had apparently fixed it, but I see that in the 9th December update it is back... 🤦🏻♂️
... View more
Thank you @SeanW I'm glad to see that you are getting a lot from the community. I found it very helpful when I first started using Meraki network equipment and am honoured to be called out for now being one of the helpers. @AmyReyes +1 for dark mode here, perhaps the gnomes have been preparing it as a Christmas present to us all! 🤞
... View more
I have done this where either an event is in just part of a building, or you want to retrict public access to reception areas etc. Simply assign a tag to those APs and set the SSID to only be enabled on APs with tag X.
... View more
