AP MODEL: CW9164I
Power Source: PoE 802.3at
The AP initially negotiates only 16W power from the switch and whenever the AP demands its regular 802.2at power - the switchport marks it as "PoE overload" and the AP powers off.
It keeps disrupting the user's connection as it is intermittent and goes on and off every now and then.
Is there a solution to this issue?
We tried moving the APs to a different port and downgrading the Switch firmware to 16.7 but issue is still on going.
- What is the switch model ?
M.
Switch Model: MS250-24P
Does the switch indicate that it has PoE budget available?
Yes, under PoE Usage
Are you using the USB port on the AP?
Hey Charles,
I have the same behavior since last week on one site.
We have two CW9166 (MR30.7) connected to a MS225-48LP (MS 16.8.)
There are no other PoE devices connected to the switch besides the two APs.
We had two MR42s before and upgraded them to CW9166s end of July. They have been working fine until last week.
I have a ticket open with Meraki regarding this already, they suggested to check the cabling first.