MeraKi - Unable to connect to wireless network

[ggill]

Unable to connect to Meraki AP

Logs on meraki indicate-  

Client failed 802.1X authentication to the RADIUS server.

auth_mode='wpa2-802.1x' vlan_id='160' radius_proto='ipv4' radius_ip='172.24.32.10' reason='radius_login_failure' radio='1' vap='0' channel='149' rssi='29'

Checked on the Radius server- authentication is successful. please guide

[marce1000]

  - Try with another client and valid credentials for sanity check ,

 M.

[ammahend]

Share full radius logs, authentication is not enough, client also needs to be authorized for network access. 

[PhilipDAth]

Is it only a single device affected, or is everyone affected?

[GIdenJoe]

If the logs say the authentication is valid, then you still need to check the authorization.
You can verify what the radius server is sending to the AP by performing a pcap on the wired port of the AP in question on port 1812 and see if you get an access accept or access reject.

[ggill · Accepted solution]

Thank you for the responses everyone.

Issue has been resolved by updating the NPS cert.