MeraKi - Unable to connect to wireless network

Solved
ggill
Conversationalist

MeraKi - Unable to connect to wireless network

Unable to connect to Meraki AP

Logs on meraki indicate-  

Client failed 802.1X authentication to the RADIUS server.

auth_mode='wpa2-802.1x' vlan_id='160' radius_proto='ipv4' radius_ip='172.24.32.10' reason='radius_login_failure' radio='1' vap='0' channel='149' rssi='29'

Checked on the Radius server- authentication is successful. please guide

1 Accepted Solution
ggill
Conversationalist

Thank you for the responses everyone.

 

Issue has been resolved by updating the NPS cert.

View solution in original post

5 Replies 5
marce1000
Getting noticed

 

  - Try with another client and valid credentials for sanity check ,

 

 M.

ammahend
Building a reputation

Share full radius logs, authentication is not enough, client also needs to be authorized for network access. 

PhilipDAth
Kind of a big deal
Kind of a big deal

Is it only a single device affected, or is everyone affected?

GIdenJoe
Kind of a big deal
Kind of a big deal

If the logs say the authentication is valid, then you still need to check the authorization.
You can verify what the radius server is sending to the AP by performing a pcap on the wired port of the AP in question on port 1812 and see if you get an access accept or access reject.

ggill
Conversationalist

Thank you for the responses everyone.

 

Issue has been resolved by updating the NPS cert.

Get notified when there are additional replies to this discussion.