MR57

Inflow1
Comes here often

MR57

As there is 2 interface in MR57,ports can be used for 10Gbps agg. throughput and POE power.... Customers want to connect both ports from different switches for HA requirement, Can we use these interface for HA purpose.  If it is possible what configuration we should do.

 

3 Replies 3
ww
Kind of a big deal
Kind of a big deal

If you have a switchstack you can use lacp

https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/MR_Link_Aggregation_Configuration...

 

In case of no stack/lacp port2 gets disabled. im not certain if port2 gets enabled when it detect a problem on port1.  (But i think not because of its called disabled and not something like standy/backup)

Ryan_Miles
Meraki Employee
Meraki Employee

https://documentation.meraki.com/MR/MR_Installation_Guides/MR57_Installation_Guide#Ethernet_Ports

 

Note: High Availability and Power Sharing will be available in future firmware versions

 
Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
Michael_Marassa
New here

We recently did an install using 5 GB Cisco 9300 switches, and had to port channel on the same switch.  We are using shared power on the stack for resiliency.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels