Issue with Access Points Functioning as Repeaters Post-Update

[Repeater-mode]

Hi all,

Following the latest update, some of the APs have unexpectedly transitioned into repeater mode. Despite performing reboots on the affected units, the problem persists, with the APs persistently acting as repeaters.

This deviation from their prior functionality is concerning, especially considering that all units were operating correctly before the update.

I'm reaching out to inquire if any of you have encountered similar challenges post-update. Please share any observations or suggestions you might have regarding this matter.

It's 4 out of 187 AP's acting this way..

[alemabrahao]

I suggest you open a support case.

[rhbirkelund]

Perhaps disable Meshing on the Network-Wide configuratino page, if you don't want Meraki to automatically mesh incase of missing uplink connection.

[Purroy]

You might be hitting the condition discussed in this thread:

https://community.meraki.com/t5/Wireless-LAN/Firmware-Network-Issue-MR30-5/m-p/220995#M30594