How to install MR30H for wired devices

Solved
DincTuna
Comes here often

How to install MR30H for wired devices

Hello everyone,

 

i am new to Meraki and we have a request to attach one printer to one of the LAN ports on MR30H Access Point.

 

Do i need power injector as well?

 

I have a modem at house and i would like to ask the cable that is connected to

 

modem  needs to be connected on WAN port which is behind right? In this case, i don't know how to use power

 

injector.

 

Can someone clarify the design for me please?

 

Thank you so much in advance.

 

 

1 Accepted Solution
WadeAlsup
A model citizen

Hi @DincTuna

 

You would want a PoE Injector between the modem or switch and the MR30H wan port if you do not have a PoE switch that will power it. 

 

See MR30H Installation Guide


Found this helpful? Give me some Kudos! (click on the little up-arrow below) and If my reply solved your issue, please mark it as a solution 🙂

View solution in original post

2 Replies 2
WadeAlsup
A model citizen

Hi @DincTuna

 

You would want a PoE Injector between the modem or switch and the MR30H wan port if you do not have a PoE switch that will power it. 

 

See MR30H Installation Guide


Found this helpful? Give me some Kudos! (click on the little up-arrow below) and If my reply solved your issue, please mark it as a solution 🙂
DincTuna
Comes here often

Hi @WadeAlsup,

 

Thank you so much your response. My first implementation on Cisco Meraki.

 

You have been very clear. Thanks again 🙂

 

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels