How for set up a 8021x PEAPMSCHAV It is mandatary to have a CA in meraki.
I decided builting a connector that fights AD.
I built a user connector with administrative privileges. .
And a user for test .
This SSID is in the mode bridge tags vlan corporative .
Muy client don't have mx; they also have wireless.
Test is wrong, any idea?
I
Solved! Go to solution.
Wrong, you cannot, it's a requirement for 802.1x. Please ready the documentation.
First point to correct, CA is not mandatory in Meraki, it is the way 802.1x works. that is, for any other vendor it is necessary to have a CA.
Second point, are you sure the communication port is correct?
Hi @alemabrahao thanks for your reply . You can deploy 8021x in NPS authentification EAP MSCHAV2 without CA .
Wrong, you cannot, it's a requirement for 802.1x. Please ready the documentation.
By the way, for Sign-on with AD is necessary to have a CA.
In order to configure a splash page with Active Directory authentication, configuration steps must be completed on both Dashboard and Active Directory, outlined below:
The following requirements must be configured on each AD server being used for authentication:
When Active Directory authentication is configured, the MR queries the Global Catalog over TCP port 3268. Therefore the Active Directory server (Domain Controller) specified in Dashboard must also hold the Global Catalog role.
If you recall, I asked you how to deploy an 8021x around a month ago, roughly. You responded that it was impossible without a CA, so I deployed in order client Sign-on with AD, which works well even though the client lack a CA.