route map on meraki ms

Solved
TheMightyGaur
Conversationalist

route map on meraki ms

Moving to Meraki to replace old core switches.  I have a subnet that is route mapped to a secondary firewall as opposed to all the rest of the traffic traversing the switch (which uses the default route).  I have the SVIs setup on the meraki and the static and default routes I need for everything else.  It says that I cannot add a specific route for this subnet as it is already being routed. There is a svi for this subnet on this switch. Also, how do i see the route table on this device (MS 425)?  Thanks in advance.

1 Accepted Solution
ww
Kind of a big deal
Kind of a big deal

Using route map for pbr?

Meraki MS doesn't support  Policy based routing. 

 

View solution in original post

4 Replies 4
alemabrahao
Kind of a big deal

Have you checked this?

 

MS Layer 3 Switching and Routing - Cisco Meraki Documentation

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
ww
Kind of a big deal
Kind of a big deal

Using route map for pbr?

Meraki MS doesn't support  Policy based routing. 

 

TheMightyGaur
Conversationalist

so my only hope is to move this off to another layer 3 device that can handle pbr?

Brash
Kind of a big deal
Kind of a big deal

That's correct

Get notified when there are additional replies to this discussion.