monitoring a whole vlan rather than just switch port

[StevenWilson]

!
monitor session 1 source vlan 10
monitor session 1 destination interface Gi3/0/14 , Gi3/0/16 - 17

The above is valid on a Cisco switch.

how can I match that on a Meraki MS355-24X?

I can see how to mirror a port, but not a whole VLAN.

[alemabrahao]

Are you talking about SPAN and RSPAN? Meraki dosen't have a CLI but you can run a packet capture on a specific port.

[StevenWilson]

the monitoring is being sent to an external server on a permanent basis, hence the source and destinations on the Cisco command lines.

[alemabrahao]

I'm not sure if it's possible. I know that you can send a netflow for a specific IP, but It's not you are looking for.

https://documentation.meraki.com/MS/Monitoring_and_Reporting/MS_NetFlow_and_Encrypted_Traffic_Analyt...

[ww · Accepted solution]

You cant. The source are switch port(s)

[StevenWilson]

Thanks for that clarification. Some commands on Cisco are just not available on Meraki.
Hopefully if I mirror a trunk port, my customer can monitor the traffic.